Review on 📱 IQ Shield 2-Pack Compatible Screen Protector for Samsung Galaxy Note 10+ Plus (Note 10+ 5G, 6.8 inch Display) - Anti-Bubble Clear Film with Case-Friendly Design by Leslie Little

I've always put screen protectors on my phones and used a lot of them. they looked really good, they cost good and i needed some as i deleted the preinstalled one on the phone when i took it out of the box. I figured it was another layer of plastic protection that might crack as I've never had a new phone with it. live and learn. They are packaged better than anything I've had before. They even include an aerosol can of the solution to help with applying it to the phone. Instructions are clear and simple, basically the same as other screen protectors except spray solution. Before ordering them I was wondering how well they would handle slightly curved edges? during the application process, the flat part went through very easily. Bubbles came out on the first try. so far so good, but then there were edges. I'm the kind of person who can look at a brand new car and if it has even a scratch, that's the first thing I see. Thing is, if the screen protector isn't pristine, I don't want one, especially as a side note. as said, the flat part fitted perfectly but the edges too with the tool, i ran my nails along the edge of the groove, discarding the first sheet and trying again with the second? However, I could not fully attach both edges. There were always a few tiny smudges on the sides that just didn't lay flat and stuck to the glass. In summary, I think these are good screen protectors. The problem is the curved sides and the perfect "sealing" so to speak with this or any other screen protector. If you are not bothered by small imperfections, most people will like them. for myself, although I just can't get over the ridges rising in places. Finally, the highlight of the Note10+ is the impressive display. anything that rings even a little bit isn't what I'm looking for. In hindsight I think if I cropped the sides and cropped about 1/8 inch or so would it only cover the flat part of the display that way? I think it would work fine if I did it all at once.