Review on Water Cooling System for MSI MAG CoreLiquid C360 CPU, Black/ARGB by Adam Kotula ᠌

There was a need to cool the I7-12700. Chassis - Be quiet! Pure Base 500. Yes, yes. 40cm dropsy in the Mid-Tower. I prikolhozil on the front panel (there were no more options) and then it didn’t fit (the thickness of the radiator itself did not fit into the recess of the case))). For installation - there is no manual, (the QR code on the box is useless), I did not delve into the MSI website. Youtube helped. A stray with an LGA-1700 socket - for the first time baffled. Cooler mount for 1700 is made of plastic! although everything else in the kit is metal. First, screw the rear mount to the motherboard (the necessary screws are in the package), then we put the water block on them and fasten them with nuts with a spring. THERMAL PASTE IS INCLUDED (1 ml). The tubes are rigid, installed with resistance to extension (But we must remember about the potential energy of a deformed body). The pump of this model is in the radiator - do not forget (connect to PUMP_FAN), only RGB wire from the water block. Copper plate is smooth. All RGB and power wires are connected to each other in series (no additional backlight controller is needed). When you turn on the PC, the colors of the water block and coolers are synchronized. In a stress test from Aida64, it gave out 83 C, in idle time 45 C. (It was 28 C in the apartment) The PC is temporarily on the table - the rustle of coolers is audible. Under the table, I think I will not hear. I am satisfied with the purchase. I took for 9100. I will ate the review.