1 Level
843 Review
39 Karma
Review on Powermatic PM HD CNC Hold Downs by Bob Souza
Works as it should
I bought these for my CNC machine because of the low profile. I made a modification and cut off the screws at the top so they don't stick out as high. So far, so good. Haven't met anyone yet. They seem a little expensive.
Pros
- T-Bolt 5/16
Cons
- Weak
New products
Comments (0)
Top products in π οΈ Workholding
Optimized Plastic Spring Photography Backdrop Support
3.48
11 Review
MAXPOWER Piece 3-4-6 Inch
4.81
11 Review
TOFL Woodworking Clamping Cabinets: πͺ The Ultimate Storage Solution for Workshop Positioning
4.19
12 Review
Enhance Your Woodworking Experience π§ with Wellmax Spring Clamps Woodworking Backdrops
4.63
11 Review
