Review on Maxxima M09300RAS Round Clearance Auxiliary by Jeff Sprunk

These 3 wire LEDs make great running and turn signals on my 16 year old aluminum tubed Wrangler. Good quality, bright, easy to connect and now I have running lights AND additional hazard lights/turn signals on the side of my JKU (not just on the grille). And the turns flash in time with my factory bulbs (not interlaced). I tried another 3-wire LED first but couldn't get it to work in both modes (running or spinning, not both) since standard two-filament bulbs switch grounds? I've seen the same on JCR Offroad and PS. About the same price but they added $10 shipping (free shipping here) and Q-tec says you have to wait 4-5 weeks. There is no schematic on the box but I found it in the reviews here (white ground, rewind/low, red turn/high). Then I noticed a 3/4" hole in the rear fenders that matches the corresponding 3/4" hole in the bodywork (leading into the taillight "cavity") so I decided to to add an additional tail/turning (without drilling) lighting. Got these red LEDs and installed them. The wiring was even simpler than the front ones (better access) and they work just as well as the front ones. Much brighter than the factory rear/side bulbs (as you can see in the picture). I think an extra side light and an extra turn signal/alarm/brake light would do, and they fit forward.