Review on Amazfit GTS 2e Smartwatch with GPS and Alexa for Men and Women - Fitness Tracker with 90 🕰️ Sports Modes, Heart Rate and Blood Oxygen Monitor, Waterproof - 14 Day Battery Life, Compatible with Android and iPhone (Black) by Adisorn Wichit ᠌

The watch doesn't weigh much. Nevertheless, there is also Amaz Fit Prostoy, so even though they are light, they are actually quite a deal heavier! Perhaps it will work out better for the ladies. The fee will now be assessed. They totaled up to nothing. They themselves were in a "deep discharge," which means that they went through a period of anxiety lasting a couple of hours. This happened because the watch was carelessly not charged while it was being charged; consequently, the battery did not wake up. To be more specific, once the charging cable was attached, the clock began to run, and it was even possible to link it to the phone. The clock indicated that it was charging at the current time. They leave once I remove it from their responsibility after an hour has passed. I reconnect, and when it's finished charging, the clock begins. And so for the next few of hours. And the presentation demonstrates that there will be no payment. I was aware of the situation since I had read about it; the issue is that the watch was stored in the warehouse for a very long time, and the factory charge had entirely worn off. they did not move for a very long time after that. Unfortuitously, as a result of this, the battery will no longer function at its maximum capacity. It would appear that the capacity has decreased. I was also able to get some advice on how to deal with the situation and bring the battery back from a deep drain. 1. Just a few hours; up to five, during which time the device should remain plugged in, untouched, and awake at some point. 2. Apply a slightly higher current, but be careful not to cause a fire; the range should be from one ampere to five volts (for more information, see chargers). I put it on an adapter that has a fast charging function for two hours, and then I used it to charge my Redmi from it. I combined these two pieces of advice. At initially, it provides a slightly increased current in comparison to standard adapters. When the monitor was restarted after three hours, it revealed that the charge had not changed. I made the decision to simply restart the gadget, and then I connected it to a power source. And, yes, he did show 80% of the charge after the overload, but after some time he showed 100% of the charge. I'm going to put the battery through some tests to see how long it will last.