Review on 📺 FORGING MOUNT Long Extension Dual Articulating Arm Full Motion TV Mount Bracket with 43 inch Long Arm, Fits 42 to 90 Inch Flat/Curve TVs, Holds up to 132 lbs, VESA 600x400mm Compatible by Reza Cook

This mount is very strong and has good stretch. However, I would not recommend it due to these issues.1. The wall plate is wide enough to cover two racks. That means it's usually unlikely to fit exactly where you want it. We had to place it right in the middle of the built-in entertainment cabinet. Using a factory wall plate to screw onto the studs would cause the TV to be 10 inches off center. The work required spanning two 16" rack bays with a total length of 32". So we asked the welder to add extensions. On either side of the mounting plate (see picture) I prefer the nice Sanus mount we had in the previous house. It came with a wall plate long enough to span two rack bays and the bracket allowed it to be placed anywhere within that space on the side, allowing its lateral position to be adjustable even after the TV was hung was. 2. The bracket is very difficult to adjust. Our TV is 1/4 inch deep and pulling it in and out of the closet is a nerve wracking experience. It feels like the TV could break because it takes too much power. Lubrication of the joints did not improve the situation. Maybe it will get easier over time if the TV doesn't break sooner.3. "Adjusting" the left and right alignment as they claim seems like an afterthought. By using enlarged screw holes, the adjustment range is anywhere you can tighten a screw within that range. Very bad. We made it, but it was a real pain. I wouldn't recommend it if you're concerned about the exact placement of your TV. For those who aren't concerned with precise placement and don't mind making adjustments, this is a very solid mount for the price.