Great product and well made which is why it gets 5 stars but the fact that there are no instructions is stupid. So I'll do her job. /nut and crossmember (leave the passenger side crossmember attached), install the new bracket and crossmember bolt/nut (no spacer needed this time) and tighten the nut. There is a hole on the side that needs to be drilled. Drill a hole to hold the new (short) bolt in place, after drilling, install the bolt, washers and nut and tighten together with the first bolt/washer/gasket and nut. At this point you can see that the crossbar is NOT aligned with the hole on the bracket. I used a ratchet strap and pulled the axle to one side or the other to line up the hole nut and tighten. Please note that the vehicle frame must be on stands and securely fastened.