My wife didn't even know our new 2013 Ford Edge had puddle lights, aka safety lights, until I replaced them with them. They are much lighter. However, I have noticed that Ford uses the same light on many vehicles and have newer LEDs. I would consider this option for two reasons. The connectors on it are unprotected and can touch, they do not fade smoothly, they knock a little. I've attached an image with instructions on how I handled the terminals. I used heat shrink tubing over them. I think the LEDs should be enough and if I need to replace them I can cut the tube. Make sure you check the operation before shrinking the tubing as it can be reversed.
Upgrade Your RV Or Camper Interior With KAFEEK 20X Super Bright LED Bulbs
38 Review
WUPP Waterproof 12 Volt Fuse Block With LED Warning Indicator For Car, Marine, RV, And Truck - Includes Fuses And Negative Bus Fuse Box
27 Review
Short Stubby Antenna For Mazda Miata 2006-2022 - 3.8 Inch, Compatible With CravenSpeed
29 Review
Smart lamp Yandex E27 8W 900lm WiFi RGB YNDX-00018
70 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review
25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review