I am a qualified welder from the American Welding Society. I am also a CWI Certified Welding Inspector. With over 12 years of experience. So I know what I'm talking about. My first impression was pretty good. Once I was able to heat the base metal enough it wasn't easy. Even with MAPP gas I was able to get the product flowing well and leaving a good roll. I've done 1" fillet welds on square tubing. But all it took was a quick tap with my 4-ounce hammer and the weld broke, a weld that was 360* or round if you like. The Putty doesn't really seem to tire of penetrating the base metal, it acts more like a surface adhesive if you will.I was going to use it to make solar panel racks for my van and bed, but no more.
🔥 Whizzotech Solder Wire 60/40 Tin/Lead with Flux Rosin Core - 0.032 Inch Diameter for Electrical Soldering (4oz/100g/0.22lb)
13 Review
309LFC-O X .035 X 1LB Spool Gasless Stainless Steel Flux Core Welding Wire by Blue Demon
12 Review
Welding machine inverter type Partner for garden MMA-200, MMA
20 Review
Continental Conti4x4Contact 265/60 R18 110H summer
23 Review