Review on 🔧 Optimized Mainboard for Creality Leveling by Michael Welborn

Name: 🔧 Optimized Mainboard for Creality Leveling
Item: 🔧 Optimized Mainboard for Creality Leveling
Rating: 5

August 23, 2022

Good auto-leveling

This review is for Ender 3 V2 firmware and Jyers. I tried it on Creality firmware and it's much more accurate and easier to use on Jyers. The instructions are pretty poor for a piece of software, but good enough for a physical install. Screw it with the right bracket and plug it into the motherboard. Ready. I did not hand level my bed in about 20 impressions and all impressions were acceptable. A good product. It's the same as the BLT, but I prefer the CR Touch's build quality and metal stylus. Remember that the needle hangs freely and will rattle as you print. I don't like it, but it's not that bad and a necessary evil.

Pros

Price

Cons

Little things

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printer Parts & Accessories

BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes

4.18

13 Review

10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length

5

7 Review

Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro –Straighten And Stretch For Enhanced Performance

4.18

50 Review

BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)