Review on 🔗 Motion Pro 08-0058 Chain Breaker and Riveting Tool: Ultimate Solution for Chain Maintenance by Anthony Wilson

The tool is not very good. I used to (1) break and install the main link in the DID520 chain. The 3.8mm pin used to break the chain broke inside the tool with very little force. I then had to use another tool to finally break the chain. When I installed the main link, the anvil that presses against the side plate collapsed. DID recommends 0.217-0.228" as the final master link rivet diameter for the chain I am using. The anvil broke and the master link rivet diameter was .220", the tooling parts were barely able to deform the rivet to manufacturer specification. All pins and Anvils in kit are made from inferior cast materials Very disappointing From a company that normally makes high quality motorcycle tools.