We have used this tool adjuster several times with our Tormach PCNC 1100 Series 3 and it works great. However, it took us a long time to figure out how to connect it. You need to connect it to the Din connector like this: Din ETS (Electronic Tool Setter) Pin 3 +12V = Red Pin 4 0V = Gray and Orange Pin 5 Signal = Brown This is very strange wiring and doesn't match any manufacturer documentation agree, but it works great. Make sure you set up your factory computer for a digital sensor and not a passive one.
Fuel Pressure Gauge - 1-1/2" Dial, 304 Stainless Steel Case, Liquid Filled, 0-100Psi, 3-2-3%, 1/8"NPT Center Back Mount
11 Review
π Pressure Sensor Breakout: Adafruit's Enhanced Portability
5 Review
Lead-Free Pressure Gauge, 2-1/2Inch Dial, Glycerin Filled, 0-160Psi/Kpa Stainless Steel Case 1/4InchNPT Lower Mount MEASUREMAN
7 Review
π Enhanced Performance Square Schneider Electric 9013FHG12J55X Air Compressor: Delivering Optimal Efficiency and Power
5 Review