Review on Autobahn88 Support 2003 2012 Mazda Black by Jack Edwards

I bought this kit as it is the only one I could find that fits my car that comes with bonnet/hood blast blocks. The kit arrived in the UK with no problems with paper instructions and a QR code to view the Mighty Car Mods YouTube video. The first impression is good. You will receive replacement hex head screws to replace the hood/lid screws. So keep that in mind as you approach this, as you'll need more than just a set of outlets. The bracket that goes all the way to the fender for the hood/hood blast kit isn't bad, although it's flat where the bolt drops for the front of the kit. The screws you seem to be reusing here were too small and could only be used on the right side, but they don't tighten all that well. On the left side it was useless to reuse the screws as they wouldn't thread into the wing. I finally managed to reuse the bolts I pulled from the hood and they fit like clockwork. I have contacted the seller to let him know about this. To fit this properly you will ideally need 4 more screws like the ones you get for the hood/bonnet to get the perfect fit here. The lifters themselves seem to be doing a good job too.