Review on BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes by Dustin Ferguson

Paired with a BIGTREETECH SKR 2 Rev B mainboard in a Tronxy X5SA Pro (Core XY) in order to add sorely needed auto Z-align capability. There are plenty of features, including the ability to swap between the graphic interface and the old classic (from which I generally would rather stay away). I particularly like the fact that when updating the TFT firmware, you have the option of choosing from a variety of themes, and I really like the "Round" theme (very nicely done!). However, I am forced to rely on the classic interface when it matters most because of the variability of the "touching". Sometimes you have to press several times to get an action, then, sometime one press gives you one, two or three of the desired action! Imaging watching Home XYZ take place three times in a row! OR, even worse, imaging manually adjusting Z to determine offset and getting 3 10mm moves! I have hit the power switch two or three times to save the grinding. Now, when doing a delicate Z maneuver, I switch to the Classic interface and use the encoder knob (which hasn't failed me so far). Alas, it is also possible to press "A" and get "B", but, this seemed to improve after updating the firmware. These are a major failing for me, and other than this, it is an easy 4 stars. Oh yes, not a single piece of paper in the box to tell you the github location to find out about the firmware updates, and there is not manual, per se, but a useful ReadMe. When you find it, be sure to read the section about Marlin compile options to maximize usefulness of this device.Well, I've got to have something, so it might as well be this. Would I buy it again? What other choice is there for a 5" graphics interface with a SKR 2?