Review on 🖨️ Removable Printing Function 220X220X250mm by Voxelab by Jose Mcdaniel

I really want to love this printer, but I really can't. It's not that it's a *bad* printer in and of itself. he's just not very good. Pros: I will say that it is suitable for printing PLA and PLA+ (I have not tried PETG or ABS). Being an inexpensive device, it's quite competent for basic printing tasks. What can I say. Disadvantages: very temperamental. You need to align the build plate perfectly - a fraction of a millimeter is enough to get a bad print. It has a weak extruder that cannot handle special threads. Example: tree. With filament like wood, which is quite soft, a single-speed extruder tends to bite into the filament and then stop feeding. As a result, when printing, you will reach a certain point where the printer will simply stop applying new layers. This has happened to me again and again with wood PLA; I haven't been able to get any successful prints despite using a thread with great reviews and excellent ratings. He also has some retiring-related eccentricities; If you're printing a model that requires a lot of retraction, you can pretty much count on heavy blocking and thermal creep. I had to completely replace the filament tube as it was severely clogged. If you are a beginner, I strongly suggest you drop this printer. I wish I had bought it and if I had to do it again I would have spent a little more for an auto level printer. UPDATE: I have bought this printer twice. The first block broke after two weeks, the second did the same. Quality control on these printers is very poor and I can only assume those who left positive reviews only printed fine details. When you print something big, you will find: problems with sticking to the bed, no matter how many times you level the bed. In fact, I found it impossible to get successful prints from this printer because these problems were so severe. I've never been able to successfully print anything other than very small tests. Also, the extruder is horribly bad and can't handle special filament at all and will clog so badly you'll have to take the hot end apart to fix it. As I said, this is the second time I've had this problem and I'm done with it; The first time I asked for a replacement but this time I just want my money back. I will use this money to buy a more expensive car. because honestly you get what you pay for.