Review on 🔒 Secure Your Fitbit Charge HR with 11-Pack ECSEM Replacement Silicon Fastener Rings - Black by Ian Welch

I am very glad to have found these Replacement Band Loops for Fitbit Charge HR. Read all reviews here before ordering. A lot of reviews said they were a lot bigger than the original and I thought they were perfect. The only thing more is the width which makes it more secure and less likely to ever break again. I have a plum/purple streak, the black color bow is a perfect substitute for the color, it matches perfectly. Note that there are those made by the same company. They say they are purple, but the color is much lighter, almost pink. Don't make the mistake of getting the ones you'll regret. I'm glad I didn't do black perfectly. The next important thing to know is not to listen to all the many reviews to heat the loop in hot water and pull over the clasp. The clasp on the bracelet rests on a spring-loaded pin, just like a normal watch on the bracelet. Just slide the strap out of the way to reveal the offset on the pin and press down with your thumbnail or something like a very small flathead screwdriver and the pin will pop out. Remove the clasp and pull out the pin, remove the old loop and put on the new one. To replace the breech, reinsert the pin and barrel, make sure the barrel is aligned to the right side of the breech, insert one end of the pin into the hole on one side of the breech and press the Pin to move it under the other side of the clasp. snaps into the hole with little effort. Takes about 3 minutes to walk the right way. I actually did it in under a minute because I knew what to do. If all you need to fix your Fitbit Charge HR is a replacement strap loop on the strap, feel free to get one. Follow my instructions to remove the clasp to replace it properly, you will be very happy with it. Richard