Header banner
Revain logoHome Page
Cody Wuol photo
1 Level
1254 Review
28 Karma

Review on 3Dman Cartridge HT NTC100K Thermistor Extruder by Cody Wuol

Revainrating 5 out of 5

Great upgrade for Ender 3!

I bought this to replace the stock heating element after the positive voltage wire was punctured and broken. What a fantastic upgrade! The hot end heats up MUCH faster and is better able to maintain temperature on high temperature filaments. The extra 10 watts forced me to auto-tune the PID controller because the machine was over-/under-catching too much initially. Great upgrade again!

Pros
  • Can be used with the new sensor heater block (temperature measurement can reach 350 degrees). Applies to CR-10S Pro, CR-X, Ender 3, Ender 3X, Ender-3 Pro, Anet A8, Maker Select V2.1, Monoprice v2, Wanhao Duplicator 3D Printer, V6 Volcano MK8 MK9 MK10 Extruder/Hotend etc.
Cons
  • I will add later