Review on Cooler for ID-COOLING SE-226-XT ARGB processor, black/ARGB by Doyun Pak ᠌

I bought this cooler to replace my current Id-cooling. I do not remember the exact series, but it is smaller. It has 4 heat pipes and a TDP of 130 or 180. Rather 180. In general, I took it in 2022 for about 1.6-1.8 thousand. And what do you think? After removing it and installing a new one, I was able to compare them and come to the conclusion that id-cooling has gone bad! The amplifier is lighter, smaller and more flimsy. the bolts that attach the rails on which the cooler is installed are so-so. Spruces are screwed into flimsy bolts. The length of the bolts is as short as possible. Four turns and that's it, they are twisted. On the old cooler, the processor was fastened with four bolts, the same ones that came from the amplifier. Now for two! You should have seen these unfortunate two bolts on these rails. They hold 1.3 kg! The funny thing is that getting into these two screws is more difficult than before in 4. From the side of the RAM, everything is still visible, but from the side of the rear wall it is no longer visible whether you hit the hole in the bolt or not. In addition, I conducted a load test and at the same speed the cooler gave the same temperature! I have a scalped i7 8700k processor. In general, I'm upset. In general, I have a feeling that this cooler was used. I send my regards to Online Trade LLC;) Traces of the intended use are attached.