Review on E3D All Metal HotEnd Full Add: Enhancing 3D Printing Performance with Premium Quality by Donnell Cursed

I got this hotend and it worked, but I kept having what I thought were bugs in my firmware because it would heat up to about 160 and then show me random things on the nozzle temp display. Once it went up to 160-180, then it started reading 20 or so, so it kept going up. As the plastic started to vaporize, I found that the temperature was much higher than 210. I continued to wrestle with my firmware, thinking it was the culprit, only to a few days later take my hot end apart and notice one of the wires is the thermistor if you pull a little if you just plug in and out of the cartridge go out. I was very careful assembling this thing, so even when it "worked" it wasn't very solid and it was only the movement of the printhead that caused it to fail.