Review on CUTEQUEEN TRADING LED Load Resistors - Fix Hyper Flash & Warning, 4PCS 50W 6Ohm + Quick Wire Clips - Ideal for LED Turn Signals, License Plate & DRL Lights by Mike Wachtel

Negative Result: Delivery took longer than expected. I ordered them at the same time as ordering new LED turn signals, the turn signals were a week before the resistors arrived. There are no instructions but that's okay, I'm an electrician and have been installing car radios and sound systems for 35 years. no problem. I installed them, one for each of the turn signal wires. bright! Wrong, nothing happened! After checking and rechecking and rechecking many times and going back to YouTube to learn how to install LED lights, how to build a load balancer, how to input the blinking display and rewrite it so the signal doesn't goes through and flashes all lights regardless of direction and so on. Finally I came across a short video "how to install resistors". I thought what the heck did I spend hours trying and looking at everything else, but oh well, that's two power/power wires to the turn signal! NOT CORRECT! You connect one wire from the resistor to ground and the other wire to the power wire that powers the turn signal. so that the restorer is parallel to the turn signal and not in series. After watching the video and testing it took about 15 minutes and all my turn signals worked perfectly. So you don't have to do anything to your system, don't have to change the flasher relay, don't add a load balancer, don't build a diode. nothing, just connect these resistors with one wire to ground and the other wire to your blink signal (4 blinkers, 4 resistors) and it will work! It took me 6 hours to install my new turn signals and these resistors. If someone gave me this information, it would take about 30 minutes!