Cutting by hand is exhausting. Saber/Jigsaw/Circular/Spiral Saw Lightweight. However, the laser is easy/simple and by far the best way to cut. I use a 40W CO2 laser. I simply cut out 1 x 1 mm pieces. These are usually small details but some of the lighting engraving illustrations get great results with this product. It smells when cutting/engraving at high power - you would have to cut very slowly and at very high power to get the flame. I don't know why I should use this kind of setting but. Apparently air support (for me) solves this problem. Acrylic also bends flames etc at high temperatures. I did not experience any buckling or flare-ups while using the product. When I want to bend I use a flashlight and then sometimes I get a flame. I always have this product on hand from this seller. No communication with the seller.
2Mm Acrylic Hexagon Blanks For Light Base, Gartful 4PCS Clear Plexiglass Sheets, 0.08" Thick Cast Plastic Glass Panel With Protective Film For Table Signage DIY Display Projects
6 Review
πΌοΈ Plexiglass Wedding Panel - 0.04 Sheet Guards
3 Review
Falken Acrylic Plexiglass Fluorescent Red Pink: Vibrant π¨ and Versatile Transparent Panel for Stunning DΓ©cor and Displays
4 Review
Nexen N "FERA SU1 205/55 R16 94W summer
33 Review
π©Ί Orthopedic Felt Adhesive by Aetna Corporation
3 Review
π₯ Orthopedic Padding Felt Adhesive: 1/4" Thick 4"x2.5yd, White Roll by Aetna Felt Corporation - Quantity: 1
3 Review
Grade Pressed White Thickness Diameter
3 Review
Self Adhesive Neoprene Rubber Foam Sheet 6"X6"X3/4", 4 Pack - Anti Vibration, Insulation & Noise Reduction Pads
7 Review