Review on Catalytic Converter 2005 2011 Pathfinder Compliant by Ricky Khan
Don't buy if you don't know how to weld and fabricate.
Item looks good until installed. Both the right and left flanges on the rear converters are offset by approximately 30 degrees and do not align with the stock exhaust pipe flanges. I had to cut the flanges and weld them back in place. Very frustrating! And you can't mix up left and right because one is longer than the other and then also the O2 sensor hole is misplaced (trust me I've tried), a lot of extra work, even for the money saved it was that not worth the hassle !
- Catalysts and parts
- Crumpled packaging
New products
Comments (0)
Top products in 🌫️ Exhaust & Emissions
TOTALFLOW 646 Mini Muffler 409SS 4.5" Round Width 4" Body 6" Overall Length Inner Inlet-3.5" Outer Diameter Outlet
39 Review
50' Titanium Exhaust Heat Wrap Roll For Motorcycle Fiberglass Heat Shield Tape With Stainless Ties By LEDAUT 2
28 Review
Nokian Tires Nordman 7 175/70 R13 82T Winter
45 Review
Gasoline generator Huter DY9500L, (8000 W)
34 Review
Another interesting products
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review