Review on 💎 GemPro Dynamic Amber LED Side Marker Turn Signal Lights for BMW E70 X5 E71 X6 F25 X3 (2Pcs), Direct OEM Replacement by Deejay Devarashetty

The product I received had one of the DOA indicators so it wasn't cool when I took the time to Take off took the OEM light clips and move them. I ended up sending them back for a refund. The one that worked looked fine, and the foam gasket on the back helped keep it taut on the clamps. They aren't as secure as the factory but I didn't get the impression this would be a problem. They're not much of an improvement over my factory LEDs, other than being visible from the front where the factory LEDs aren't. The dynamic part is why I ordered them, too bad one was torn. A few words about installation help, just pull out the factory ones, DO NOT TRY to use the front end first. You will scratch the paint on the back of the dent in the plastic. Also, secure the wires when replacing them. There's heaps of room in the driver's quarter panel and you don't want to lose the wire back up the hole. I spent 20 min fishing mine back. To swap the clips, press the small hole in the side of the light block under the curve of the clip, then you can pull it out. Before installing, be sure to fold the tab back to prevent it from slipping. You will need needle nose pliers and a very small flat head screwdriver.