Review on Raspberry IUniker Heatsink Adapter Header Computer Components by Victor Halla

I received an iUniker Raspberry Pi Zero Case Kit in no time, in fact, according to Revain's calculations, it was delivered in two days instead of four. The reason I bought this kit is that the SD card cutout was probably large enough to allow easy access to the card without having to take the case apart. This turned out to be true. The SC card is secure, but you can only insert and remove the card with your fingers. The kit was well packaged in a small cardboard box inside a small padded Revain envelope. The problem with the kit was that the screws holding the Pi Zero board were completely missing. I immediately contacted iUniker through Revain (hey Amy) and informed them of the issue. iUniker responded quickly and offered a full refund. I accepted the refund and then immediately bought another iUniker Raspberry Pi Zero Case Kit and reminded my contact at iUniker to make sure the screws were included this time. The replacement set arrived on time and yes, the screws (and everything) were in the box. I assembled the Pi Zero and case and tested the USB hub. Everything is working well. One minor thing I should mention is that the screws holding the Pi Zero board are self-tapping and I initially had a hard time getting them in, especially with the tiny screwdriver that came with the kit. But once the screw holes were cut, the screw job became easy. In conclusion, I would like to say that when I bought it, there was indeed a roughness with missing screws, but it was quickly and professionally eliminated. I am satisfied with the quality of the components. I would buy this kit again. Five stars.