Review on Wall Mount UltraMounts UM 832T, black by Mateusz Rzeczycki ᠌

ordered last time the bracket without hangers. it was inconvenient to fix the telly, but he had a much richer kit. the bolts were put longer than the dowels, I immediately ran into this. not prepared for sockets inside and nearby, if the weight is 250 or less. I had to quickly crutch the plastic washers, by the way, there were a lot of them with cheap ones without hangings, and in the end it turned out that the telly had moved away. the washers for the screws do not fit, which are twisted into the telly, literally fractions of millimeters, I had to use my own. the variety of screws for attaching the telly itself is long, I had to build it up on my own (it’s a pity there wasn’t a grinder at hand, it would have been easier) the washers on the hangers interfered with the sockets again, I had to disassemble and change to my smaller ones. All these comments are visible in the photo. in general, I would not recommend this for purchase, especially if there is neither a 3D printer at hand, nor a set of screws, nuts, washers, or, at worst, a grinder.