Review on Digital Angle Finder Woodworking Electrical by Lequon Kaneshiro

I bought this digital angle gauge primarily to use with a knife sharpener to set sharpening angles. But I also have a table saw, which is perfect for adjusting the blade for miter cuts. It can also be used as a simple spirit level for hanging pictures, etc. This meter uses two AAA batteries (included). Easy to turn on/off and turn off when not in use for about 3 minutes. For woodworking, the gauge has a magnet on the bottom so you can attach it directly to the table saw blade to adjust the angle. It comes with a nice fabric storage pouch that has a belt loop to hang it on your belt when needed. The only thing I don't like about this sensor is that you have to use a small Phillips screwdriver to get to the battery compartment. This is not always convenient. It would be much better if the battery cover could just snap into place. This is a minor complaint, however, and unless you plan on taking a lot of measurements, the batteries probably won't need to be changed very often. Overall, this is a great little sensor for aligning things and measuring angles accurately. It is also very cheap to buy.