Review on Enhanced Flexibility with πͺ Creality Original Magnetic Removable Base by Kenny Sarma
Probably the best option for PLA, but not for very long.
I've had glass, polyethylenimine and fiberglass and these flexible magnetic surfaces are my favorites for PLA. They settle very well at 65C and I have no problem lifting on my CR-10 Pro v2. The only problem is that parts with a large surface area are difficult to detach and can end up being damaged. No deal breaker. I have found that I need to replace the finish after about 50 or 75 large parts or a few hundred small ones. It's cheap enough and I don't mind, and I have to balance the cost with the cost of wasted filament due to shots or other bad prints. So I'm satisfied.
- New
- Slightly torn
New products
Comments (0)
Top products in π¨οΈ 3D Printer Parts & Accessories
BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2
13 Review
10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length
7 Review
BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes
13 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
Another interesting products
Economic Ender 3D Printer DIY Kit With Resume Printing Function, Large Printable Area Of 220X220X250MM By Creality 3D
18 Review
π¨οΈ FLASHFORGE Adventurer: Enhanced 3D Printer with Removable Extruders and Monitoring Features
4 Review
UV Curing Standard Photopolymer Printer by IFUN
5 Review
Flashforge Adventurer 3D Printer with Detachable Precision Leveling System
6 Review