Review on 🔀 MCSADVENTURES Polaris Ranger RZR 800 900s XP 1000 ATV UTV Fan Override Switch Kit (Toggle Switch) by Ted Slaughter

Install this on a 2011 Polaris Ranger XP. Took about 2 hours in total. Works perfectly! Since it fits different models I think it would be impossible to add some instructions. Basically, you need to remove the plastic cover in the fender on the driver's side, which also helps when removing the wheel. This gives you good access to the fan connector. As a note, peel the flat ends off the switch and route the cables through the Polaris chassis from the bottom, as there isn't enough room to pull the plugs out through the narrow opening where some cables are already present. Disconnect the fan connector and connect to "Y” on the switch set. From the top, slide out the bezel connector on the dash, push the wires through and reconnect to the switch. Press the plate until it clicks into place. Connect the power cord to the positive terminal of the battery and you're done. I had quite a bit of spare power cord so I cut it to length to make the build cleaner. The kit includes zip ties, crimp connectors for insulated wires and rings.