Review on 🖨️ Enhanced Printer Thermistor Sensor: Reprap Comgrow - Reliable Accuracy for Optimal Printing by Chris Bowden

Name: 🖨️ Enhanced Printer Thermistor Sensor: Reprap Comgrow - Reliable Accuracy for Optimal Printing
Item: 🖨️ Enhanced Printer Thermistor Sensor: Reprap Comgrow - Reliable Accuracy for Optimal Printing
Rating: 4

August 24, 2022

Limited time (updated)

Bought last October and works great for Ender 3 Pro. The installation process, but not terrible. The only problem is that after about 5 prints I get a low temperature warning. It's very frustrating when you get 50% or more of a print and then have to throw it away. Then you need to repeat the process of installing another thermistor. Good thing they send you a ton of it. 1 star from me. Support contacted me and sent a replacement. After doing 2 more after this check I found that the wire next to the glass thermistor was burning. I used high temp sealant to hold it in place and it still burned out. Might upgrade my printer to Ender 7 soon.

Pros

Nice to use

Cons

old

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printer Parts & Accessories

Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro –Straighten And Stretch For Enhanced Performance

4.18

50 Review

BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes

4.18

13 Review

BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)

1.94

7 Review

Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards

4.14

19 Review