🖨️ Enhanced Printer Thermistor Sensor: Reprap Comgrow - Reliable Accuracy for Optimal Printing Review

My new Ender 3 V2 was printing every 5 minutes before the nozzle thermistor failed. It started heating up the nozzle and then the screen restarted and the temp showed 0. I ordered them and they arrived in a day. To my surprise, the cable was 4-5 inches shorter. I ended up cutting off the end of the old cable, soldering them together and heat shrinking. Works great but they must be the correct length for Ender 3 as stated in the description.

Accurately reads temps; Working product with no damage or broken parts. The connector is standard on most if not all 3D printer motherboards (two-pin XH). , that's 4" short for an Ender-3 as an exact replacement. It can still be used, but the wiring for the fans and heater cartridge is looped over the assembly if you still want to use a grommet to tie them together I haven't tried typing anything that maximizes the amount of print, so I don't know if the lack of size would hurt anything.

Bought last October and works great for Ender 3 Pro. The installation process, but not terrible. The only problem is that after about 5 prints I get a low temperature warning. It's very frustrating when you get 50% or more of a print and then have to throw it away. Then you need to repeat the process of installing another thermistor. Good thing they send you a ton of it. 1 star from me. Support contacted me and sent a replacement. After doing 2 more after this check I found that the wire next…