Review on License Bottom Licenses Replacement Vehicles by Brian Kingsford

Replaced the old dealer frame on our T-Bird with these - the clean black frame looks much better and matches the black mounting points. It was relatively easy to install. The plastic washers and caps work well and snap into place while maintaining the black, streamlined look. The only reason it doesn't get 5 stars is that there are small clips on the back that hold the panel in place on the opposite side of the frame from the screws. a bit small so they don't hold the license plate in place like I would like. - There were two plastic discs in the caps when the goods arrived. They were difficult to get out. The only installation issue I had was that our faceplate bracket (required in California but not all states) was installed upside down with screw holes on the bottom. So, due to the small bracket issue mentioned above, it was a bit difficult to install the panel and frame while holding the panel in the brackets. Also, the top of the frame wobbles a bit and the plate wobbles a bit. This is not the fault of the product, it is related to it. If I have time I will take the time to flip the holder or find some other solution to stop the slight rumble.