Review on 🔌 Grounded Control Charging for Enhanced Insputer Outlet Functionality by Sean Spence

I ordered this insputer socket with two USB ports for my RV installation. It has replaced the regular outlet under the cushions in my dining area so I can charge my devices while sitting there. As it turned out, the unique design of this outlet was perfect for my application. Due to the fact that RV sockets without an electrical box are rather uncommon I was concerned that I might have to widen the hole, but this fits in well. It also has a slightly different design for how the wires are connected. It has two small holes on each side for the neutral and hot wires with a small pan head screw that tightens the inner terminals once you put the wires in the holes. The ground wire is attached in the conventional manner. Just make a shepherd's hook on the wire, place it under the screw and tighten. a bit easier to install in an electrical box than my others. My only concern is that when I check the voltage between the hot side and ground, I only get 14 volts from the front of the outlet. But when I measure the voltage from the hot wire to the ground screw on the back I get 120 volts. I asked a question on the seller's site and it hasn't been answered yet, but I'm wondering if this is a function of the electronics in the device? When I hook up a circuit tester it says it is properly grounded and polarized. But otherwise I am completely satisfied with this socket and find the asking price very reasonable.