Purchased for use on a 2000 VW Passat. It came with a gasket that was too thick for the adapter cap. Few threads were visible and it didn't pull tight (see photo, subject said at least 3 full threads should be visible). Air leaks and it pops out when I tighten it tight. I contacted Motive, they sent me a thinner gasket. It still pops out if I overtighten. Once it's managed to seal, try not to make it too tight or loose. After that it was no longer possible to get a good print. I only had to apply 12 pounds of pressure to prevent an air leak. When bleeding, the brake fluid ran out of the adapter and made a huge mess in my engine bay and a puddle on the floor. Contacted Motive again at (408) 612-2687 and asked for a replacement adapter. They didn't answer. I do not recommend this product for VW/Audi due to poor adapter installation. (You should be aware of this flaw in their product as they sell more expensive aluminum adapters as an alternative to cheap plastic adapters.)
π§ Adjustable Engine Cylinder Hone Tool - EWK 1-1/4 to 3-1/2 Inch 3 Stones, Deburring Piston Honer with 220 Grit
9 Review
Wostore Double Flaring Tool Kit with Copper Line Tube Cutter: The Ultimate Solution for Precise Flaring!
35 Review
JQuad Safety Orange Powder Caliper
9 Review
Universal Car Ratcheting Caliper Piston Tool with 2 Steel Plates - Brake Caliper Press (Red, Two Size)
9 Review