Header banner
Revain logoHome Page
Paul Vanlaere photo
Spain, Madrid
1 Level
725 Review
34 Karma

Review on ๐Ÿ”ง Enhanced Dorman 615-188 Intake Manifold for Preferred Ford Models by Paul Vanlaere

Revainrating 4 out of 5

Works great. I have almost 3000 km mileage.

Working properly. I've ridden it about 3000 miles and so far no problems with my 01 f250. As long as your matting surfaces are clean and you meet the torque requirements, you shouldn't have any problems. Make sure you don't need to install an o-ring for the PVC system. Installation took me about 4 hours. If you are a first time mechanic this can be a bit tricky. I used to be a mechanic but now only for my cars so the task wasn't difficult. Any garden mechanic can do this job. The only issue I had with the product was that there was quite a bit of burr between the product's matte surfaces, but a quick blade cleaning took care of that. I didn't pay attention to the screws on the case, but they work fine. I ran into an issue where one of the holes that should have been there for the fuel mount wasn't made, but a good drill bit fixed that issue. My only recommendation is to install the fuel rail on the inlet before reinstalling it. The noise seems the same, MPG hasn't changed, just fixed my air leak and poverty codes. All in all I would buy again for the price. Not the best quality but it works.

Pros
  • Engines and engine parts
Cons
  • Nothing