Review on Kemimoto Kawasaki 2 Seater 4 Seater Models by Robert Lemons

Couldn't justify $180 for a highlifter so I waited for an Amazon equivalent on ebay, caught it as soon as it caught my eye. The packaging was great, the parts looked like highlifter clones, very thick, class 8 bolts, the instructions weren't english, took me about an hour and a half to install them along with 2" wheel spacers on a frosty tool hunt. The only downside was figuring out the orientation of the screws and figuring out how to move the spacers in the back without blocking access. Note that you bolt on the rear shock first, then hold the arm down and the brace to the diff. When it's time for the bottom bolts, line up the brace, insert both spacers, slide the middle one, drill the bottom hole, use a screwdriver to drive the bottom spacer into place, finish drilling the other side of the bottom hole using the spacer as a drilling guide, insert the screws and tighten everything. Instruct ructions detailed this process, but hey, it's not that hard, you should be able to figure it out without instructions if you're a bit mechanically inclined. Will upload before and after photos if I remember later.