Review on 🔧 ANBOO Mini Micro Tool Attachment Set - 8 Piece Vacuum Attachments 1-1/4inch & 1-3/8'' by Wendy Parks

This set was a bit confusing at first until I poked around a few times to figure out how the attachments connect to the main connector that connects to the vacuum hose. First, the 1/2 inch hose you see in the photo for this kit is the hose that you connect the various brushes and extension tubes to. The end that connects to the vacuum cleaner hose has a screw cap that controls the suction strength and there are two additional suction hose connectors for different sized hoses. All the tools/hoses/brushes seem useful and durable enough. I've used two brushes to clean the inside of my computer and they get into places that are otherwise difficult to reach with a standard sized brush head. If you put a 1/2" hose attachment on the end of the fitting that connects to the vacuum cleaner hose, you can *first* put some lube on the plastic barbs before sliding the small hose over the barbs. Found out the hard way that those barbs really do hold that little hose. In my case I decided I wanted to shorten this little hose and tried to pull it out. Good luck with it. I cut the tubing just past the plastic barb end and then used a small pair of scissors to cut off the piece that was still stuck in the barb. Not once, but twice did I manage to jab my thumb to dislodge this small piece of tubing. A bit of silicone grease (or petroleum jelly would work too) and the hose is still very snug and won't fall off, but I can now pull it out if needed. Good price, does what it's supposed to, and while I'm crazy about the hose, it's actually a good design because you can thread this 1/2 inch hose between parts of the computer where a larger connector won't fit. If I wasn't wearing a patch I would give it a 5. ;-)