Review on Dorman 03133 M10-1.5 x 62mm Exhaust Stud Kit for Compatible Models by Amrozi Goodall

Had to replace one of the three studs in the driver side manifold. Some kind of jack pulled the nut and completely stripped the thread. I had to stand upside down and cut the bobby pin with a grinder/cutter wheel. The other two were taut but separated. On a collector on a workbench (woman's flower bed) I cut off the back end of the stud flush with the flange with a grinder. Then I cut the long side of the bolt down to about 1/4" and weld on the nut. On the first try the nut came loose. Welded the nut again and hit the flange with a hammer a little. This time the bolt broke the bolt If you don't have a welder or an oxyacetylene torch, the original studs will be very difficult to remove.