Review on 🦩 Pelican 1052 Foam Set in Grey for Pelican Products 1050-400-000 Case by Edwin White

Great product. Small squares cut out of foam allow you to make an individual protective cocoon for any electronic device. The foam comes with small squares partially cut the full depth of the foam piece. To adjust the foam for your electronics, simply loop around the camera (or whatever you're trying to protect), then carefully detach the small foam bridge connecting each square to its neighbor and remove the square from the rest of the grille . YouTube describes this process quite well. The only thing that bothered me about using the foam was that I was a bit unsure how to detach each square without pulling the square all the way out, leaving nothing but a square tunnel across the full depth of the foam padding . To try to cut the squares at the same depth I used a knife to cut the squares all over the foam. Works fairly well and matches my electronics - not as good as professional work but good enough for government work.