I hope you used Ctrl + F to find it. The idea of this tool is similar to the tool for removing bicycle cranks. I used this to remove my Ninja 250's flywheel to replace my starter gripper. However, there are some caveats: although it screws onto part of the flywheel, the pin that comes with this tool is not long enough to make contact with the axle that the flywheel sits on. How to fix this before I continue just want to say that if you don't like what I'm about to describe you don't, I used a 6mm 1/4" deep socket and screwed it into the threaded part inserted .where the screw was that was held to the bodywork.if you do this use extra care.hope this helps and again do this at your own risk.the reason i did this was that I really needed to fix my bike and had no intention of interrupting my riding days because of a silly obstacle, an alternative is to buy a longer extraction pin.
DPTOOL 6PCS Camshaft Phaser Timing Chain Tools for VW Chrysler Dodge 3.6L 10200A+10202 High Performance Engine Kit
9 Review
🔪 Efficiently Cut Exhaust and Tailpipes with GEARWRENCH 2031DD Cutter
9 Review
Complete Ford 4.6L/5.4L/6.8L 3V Engines Repair Tools Set - Valve Spring Compressor, Crankshaft Positioning Tool, Cam Phaser Holding Tool, Timing Chain Locking Wedge with Crankshaft Pulley Bolt
10 Review
🔧 Honda Valve Adjusting Wrench 10mm by Powerbuilt
9 Review