Review on Official Creality Upgraded 3D Mainboard by Vera Gashi

Name: Official Creality Upgraded 3D Mainboard
Item: Official Creality Upgraded 3D Mainboard
Rating: 5

August 25, 2022

Easy grid alignment with this device

Added Bltouch to my newly purchased Ender 3 v2. Comes with 3 different mounting brackets and all necessary components. I used a piece of polyethylene to thread through the cable sleeve and pull it through for a snug fit. A simple upgrade of the printer firmware as well as grid and screen alignment were easy to perform. There are many videos on YouTube about this. Then a simple command is added to your slicer's gcode to enable the grid for printing. Significantly better print quality due to better table alignment than with sheet technology.

Pros

High accuracy

Cons

So far so good

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printer Parts & Accessories

Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro –Straighten And Stretch For Enhanced Performance

4.18

50 Review

Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards

4.14

19 Review

BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2

4.29

13 Review

BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)