Review on PPX Gray Dishwasher Rack Tine Prong Repair Caps 🔧 - 200 Pcs, 1 Inch Round Tips - Easy Push-On Installation by Zachary Benjamin

Easy Installation Tips: - Heat half a glass of water to around 165 degrees - Throw in a dozen plastic tips - Remove the tip from the water one at a time and press on the rack's open prong, rotating when pressed. - After this dozen has been applied, microwave the water for 15-20 seconds to reheat. - Repeat until you're done. Notes: - Do not heat water above 170°C. This allows the plastic tips to become too soft and cause them to tip over when you press on them. Water colder than 150C will still soften the tips a bit, but I found 165C to have a golden spot where the tips were buttery soft and required little to no effort to apply , so I microwaved the water in between sets. Product Rating: So far, so good. I've only worn them for a few weeks and none have fallen off or deformed. I wish they came with instructions so I didn't have to deal with the hot water logistics myself because trying to install them cold/dry was awfully difficult.