Review on π» Runmade 2011-2014 Sienna Manual Radio Antenna Base Bezel: Compatible with Toyota 86392-08020 by Shawn Bass
It is very important to heat before installation
The antenna cover is made of a very hard rubber-plastic material. I tried several times unsuccessfully to fully install the boot into the fender before warming it up as recommended by several reviewers. After 5 minutes of boiling in water, the boot is much more comfortable to handle, snaps in instantly and looks just as good as the original equipment. The part is expensive for a small stamped component but worked as advertised. The manufacturer should recommend heating before installation.
- Consistent test results
- A newer model could have been chosen
New products
Comments (0)
Top products in π‘ Antenna Toppers
ποΈ High-Performance 7-Inch Spiral Antenna for Harley Davidson Touring Electra Road Street Glide Trike Ultra Classic CVO (2-Pack)
9 Review
π» Rydonair 13-Inch Flexible Rubber Antenna Replacement for Dodge Ram 1500 (2012-2021) - Enhanced FM/AM Reception Design
8 Review
π Enhance Your Vehicle's AM/FM Reception with the Mega Racer Bending Truck Antenna - 7.0 Inch Universal Fit for Trucks and Cars - Anti-Theft Design and Car Wash Safe - Black
9 Review
Set of arches and supports Lux Classic Aero 52 for roof rails universal, 1.2 m, for roof rails, aerodynamic, arch length 120 cm
12 Review
