Review on Goldenwarm 10 Pack Black Cabinet Handles 3-3/4In Matte Black Drawer Pulls Modern Style Black Cabinet Hardware Cupboard Handles Bathroom Cabinet Door Handles, 96Mm by Matthew Mosley

I originally purchased this style of cabinet handle in order to go from having one hole cabinet and drawer knobs to a two-hole cabinet and drawer pulls. The design of this pull allowed the center hole in my drawers to be covered when drilling two new wider holes for this pull. Or at least, that was the plan.Unfortunately, the screws were too long. I reached out to the manufacturer and they do have other sizes available based on the cabinet thickness. I measured my cabinet thickness and it was supposed to fall within the shortest screw they had available. I ended up realizing that the holes in the cabinet handle do not go as deep as other cabinet handles. I had already drilled some holes and were forced to try to use the screws. I ended up having to buy washers from a hardware store to which added quite a bit to the cost.While other cabinet pulls may allow a screw to go in deeper (and thus fall within the cabinet thicknesses)In order to reduce the headache with the flawed screw hole depth of these pulls, I ordered brushed brass knobs from the same manufacturer, but different product family. I was concerned about mismatching colors, so I reached out the manufacturer who replied and assured me that the "Brushed brass" / "gold" would look the same across product lines. They are close, but they do not visually look identical. I guess that this may be due to the amount of "brushing" finish that is done to the handles. The handles of these pulls are less brushed/more glossy and therefore appear more gold/yellow against light than the knobs. It's hard to see in photos but in person with light reflection it is easier to tell. I purchased other normal cabinet handles from this same vendor for another place and the "brushed brass"/"gold" was close to the knobs -- it appears this particular style/handle may be the outlier.One last tip: The proper screw for these handles are M4 (0.7mm). My current knobs had #8-32 screws -- learned the hard way that I couldn't re-use them, as they are extremely close in size to one another.If I could do it again, I probably would not have ordered these pulls. Extremely frustrating and a headache.