Review on 📲 RinoGear Clear Film Screen Protector Case-Friendly for Xiaomi Huami Amazfit Bip (6-Pack) - Accessory for Full Coverage Display Protection by Roman Starr

This technology is available for a medium range of products. This applies to both flat and rounded edge screens (my watch is BIP). It can be applied wet (with a supplied or homemade soap solution) and is easy to apply and place, although it is quite slippery at first, making it easy to apply. You need very clean fingers and a dust-free workplace, such as a clean wiped table top or a clean table top. I chose a clean kitchen towel for my hands. This documentary is a video that can be viewed in minutes. Pick from the video to find the one that most closely matches your setup, although the differences between the two are mostly in the small details. The process is pretty simple. Clean the surface of dust and particles with the supplied cloth. This results in the large bumps that are so common among screen protectors. Take a screen protector and wet it and your fingers with the solution. You can then place and move it freely on the screen. It will slide, so you'll need patience as you're just removing all the visible bubbles. The tiny, hazy microbubbles will disappear later, but you should be able to get most of them out. Then take a break of at least 10 minutes. At this point the protector will hold in place fairly well with careful handling. You can additionally swipe to remove more bubbles and press on the edges. If it rises on a rounded surface, don't worry. Then let it sit for half an hour to maybe 2 hours and then lower it and press down the edges as shown in the video. At this point the edges become stickier and at this point you can't move the bubbles in the middle. Soon after, it can be turned on (if you turned it off) and used. The haze should disappear within a few days. If all of these fail, you can try again if your product came with more than one screen protector. I am impressed with the wet application of this particular film.