Review on 💡 Resistant Indicator for LGL Self-Test Receptacle by Mike Newbill

This is complete rubbish. Maybe this brand was once decent, but not anymore. You can see in the picture I've attached to this crap that unlike regular sockets (2nd picture), even regular GFCI sockets (not pictured), these screws screw into a recessed channel that the screw does as well can hardly catch without the wire he needs. To keep. As you can see, in a traditional store, most containers are refilled immediately. With them, you can hardly catch the thread with the wire. I say hardly because I managed to hook one to one of the cables or load screws, but I never managed to get the ground screw to hook. And if that's not enough to make installation impossible, check out the screw that's still there. For some unknown reason they countersunk the area where the screw sits, but the part that sticks out is still so close to the screw head that you can't run a wire between the head of the screw and that edge. Due to the ridiculously short screws and the aforementioned idiotic strategy of screwing them into a recessed thread channel, the simple procedure of wrapping a piece of wire around the screw is nearly impossible. This leaves you with two options. You can thread the straight end wire under the slightly loosened screw and try to create a bend/loop in place with needle nose pliers. FUNNY! OR you can accomplish the equally impossible task of loosening the screw while holding the wire while trying to screw the screw back into a recessed threaded channel that has less than a millimeter of grip. I have tried 4 of the 10 included in the pack and they are all the same. COMPLETE TRASH!