Review on Mookis 77PCS Paintless Dent Repair Kit - Golden Dent Lifter, Slider Hammer, Bridge Dent Puller & More - Effective Dent Remover for All Car Body Types by Darius Glatzel

Just received the kit a week ago. It really includes all the items in the first picture. All items worked fine. i really love her In addition to the seller's description, there are some tips to pay attention to: 1. Find a dent in the line board (by refraction of light) and clean it with a rag and alcohol.2. Then wipe the glue stick with alcohol to remove grease from its surface. (It will increase the viscosity of the glue.) 3. Put the glue into the glue gun and connect the gun to the power supply, then heat it for about 2-5 minutes until some hot glue comes out of the gun.4. Choose an inlay that looks like a dent and notice the hot glue that should start from the center of the inlay and spread it in a circular motion, covering the inlay but not going beyond it. (The larger the tab, the stronger the hold. So if the dent is large, choose a large tab.) 5. You need to quickly glue the tab to the dent and press until the hot glue sets. (This is the best application time and the strongest glue viscosity when the hot glue has cooled down but still has some residual temperature, it takes about 0.2-5 minutes until you feel it with your hand.) 6. Fix the dent lifter or dent lifter in place T-shaped repair tool, hammer or bridge puller and hold the two handles, gradually increase and decrease the force, repeat your steps until the dent is repaired or flattened, and don't let the tongue fall off the body. . Also, you need to watch your strength and take your time .7. After the repair, spray the adhesive remover on the area where the adhesive is covered and remove it with a 0.8 scraper. Check the recovery effect again. If it's not good, repeat the above steps until it's fixed. Recommend these tools. DIY is a lot cheaper than a body shop.