Review on Creality Magnetic Flexible Removable 235X235MM: Unbeatable Printing Precision and Easy Bed Adhesion by Edwin White

I have several other printers with detachable magnetic build plates. But my Ender3 didn't have that. I had to use clamps to hold the construction nail. Not the best experience. This simple and inexpensive solution easily solves this problem. It took about 2 minutes to install and fit perfectly. It's just a little wide and long, but not in a bad way. It comes off easily, but not so easily that I would expect any printing problems. I had a small problem with air bubbles, but this was an easy fix. Just poke a hole in the spot and let the air out. I think if I had applied it when the bed was a bit warm it wouldn't have happened. Since the magnet and base are a pair and you may end up with one that doesn't line up with your last magnetic sheet when replacing the construction nail, I can verify at this point. I'll try to remember to update this. Overall a great product. Exactly what I wanted and expected.