Creality Magnetic Flexible Removable 235X235MM: Unbeatable Printing Precision and Easy Bed Adhesion Review

DO NOT USE WITH ABS PETG OR NYLON. DO NOT CLEAN WITH SOLVENTS. it had excellent adhesion to the print, especially since I switched from borosilicate to ABS prints with absolutely no adhesion. I had two good PLA prints until I unknowingly switched to ABS with a layer temperature of 85C. There were no adhesion problems when printed, however, removing the print destroyed the print and parts of the edges could not be removed from the surface, destroying the surface. great bang for the buck if you…

Prints fall off the plate incredibly easily. However, forget about any skirts or lines. The specs specifically state that the surface is NOT SCREAMING, but if you intend to use this slab more than once then you have no choice. I prefer this plate over the standard plate that came with my Ender 3, but it's far from perfect. You have to damage the plate to remove the skirts and lines. This scratching will clearly affect future prints. This is mostly suitable for certain prints, but for some print

I have several other printers with detachable magnetic build plates. But my Ender3 didn't have that. I had to use clamps to hold the construction nail. Not the best experience. This simple and inexpensive solution easily solves this problem. It took about 2 minutes to install and fit perfectly. It's just a little wide and long, but not in a bad way. It comes off easily, but not so easily that I would expect any printing problems. I had a small problem with air bubbles, but this was an easy fix.