
Installed on a 1999 Jeep Cherokee 4.0. Comes with all o-rings which is nice. The fit was perfect and it sealed immediately. The lines do not use the same Schrader valves as the OEM and the shredder used on the low pressure side is too high. The gauge hooks pushed too hard and damaged the new Schrader valve. This hasn't happened to the OEM and shouldn't happen with a new kit. I went through the whole process of vacuuming the system and filling it with coolant. Thought I was almost done. The air conditioning is blowing cold, I want to disconnect the hoses from the gauges, and all my coolant has leaked out of the Schrader valve. I had to drive all over town to find the right Schrader valve. Finally found it after two hours and I had to strike a delicate balance between getting the seal right and damaging the schrader valve to finish my job. The loss of coolant cost me β¬40.

Gooacc 50Pcs Hood Insulation Retainer Clips - Perfect Replacement For Grand Cherokee, Dodge Ram, Chrysler PT Cruiser, Plymouth Laser, Neon - OEM Part Number: 4878883AA
33 Review

Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review

820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review

25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review