I did not use this as intended but it worked fine for my 1971 Monte Carlo Fuel Gauge Signal Wire. I had to close the nest a bit with pliers, but it worked great. The original is very difficult and expensive to get, after soldering it into the factory wiring harness there were no problems. The fuel level sensor reads as it should.
Short Stubby Antenna For Mazda Miata 2006-2022 - 3.8 Inch, Compatible With CravenSpeed
29 Review
Upgrade Your Light Bar With NAOEVO 14AWG 240W Custom Wiring Harness And 6 Modes Light Bar Controller
29 Review
Smart lamp Yandex E27 8W 900lm WiFi RGB YNDX-00018
70 Review
WUPP Waterproof 12 Volt Fuse Block With LED Warning Indicator For Car, Marine, RV, And Truck - Includes Fuses And Negative Bus Fuse Box
27 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
Gooacc 50Pcs Hood Insulation Retainer Clips - Perfect Replacement For Grand Cherokee, Dodge Ram, Chrysler PT Cruiser, Plymouth Laser, Neon - OEM Part Number: 4878883AA
33 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review